Saniflo Up - The Original Saniflo Macerator - 6001

Saniflo Up - The Original Saniflo Macerator - 6001

Add a water closet in your basement, and you increase the value of your home. You add convenience. You face a potential plumbing nightmare. Plumbing vents up, toward your roof, and that's why you need something to force water upward if you place it too low. In other words, you need the original Saniflo macerator to make your plumbing work. This handy little machine takes water closet waste and delivers it where it needs to go. It works perfectly with vertical plumbing systems. Inside, the Saniflo macerator is made with an induction motor, no brushes or gears that will wear out in time. The wide casing design reduces noise. The original Saniflo macerator is made with hard-wearing neoprene, stainless steel, polypropylene and C.R.P., and it's made to last.

Please note: The dimensions shown here are of the unit only and do not allow for these additional space requirements as they may differ for each installation. It is the responsibility of the purchaser or installer to ensure that the Saniflo product selected will fit in the chosen place of installation with due allowance for pipework runs, electrical connections etc.

For best installation practice please observe the following:

Avoid any contact with the walls of the room when fitting the tank.
Make sure that the anti-vibration pads are properly stuck underneath the tank at the

indicated locations, to minimize vibrations.
Screw the fastening tabs to the floor to prevent the appliance from moving.
Position the tank on a perfectly level floor so that the anti-vibration pads can work effectively.
Fasten the outlet piping correctly avoiding any distances between attachments in

excess of one metre.